1X12 AES/EBU Digital Audio Distribution Amplifier, Re-clocked – 110 ohm XLR I/O

889,90 € HT
1.064,32 € TTC
Catégorie : Distributeurs
Marque : ATIAUDIO
Référence : DXA112-XLR
The DXA Series of Digital Audio Distribution Amplifiers is designed to regenerate,
isolate and distribute digital audio data formatted in accordance with
specifications AES3-1992 and IEC 958. This is commonly called AES/EBU
formatting.
DXA112-XLR models use XLR connectors and operate from and drive a 110-ohm balanced shielded twisted pair distribution system per AES3-1992.
Disponibilité : 2 semaines
 
  • Accepts sample rates from 27 to 96kHz
  • Loop-thru transformer balanced and isolated inputs
  • Switchable input termination resistors
  • Individual, transformer balanced and isolated 110 ohm XLR outputs
  • Individual isolated 75-ohm BNC outputs
  • Single or dual inputs
  • Up to 12 XLR or 24 BNC outputs
  • Quiet, internal linear power supplies
  • Attractive, one rack unit package
Connectors: XLR female or BNC, DC isolated from chassis
Input connector pairs paralleled for loop-thru
Level: 200mVp-p minimum
Impedance: Transformer isolated, capacitor coupled, balanced and
floating, XLR inputs 110 ohms; BNC inputs 75 ohms
Terminating resistors may be switched in or out on rear panel
Cable Length: 300m (about 1000 ft.) of 110-ohm cable, 1000m (3280 ft.) of 75 ohm coax (with equalizer)
Sample Rates: Accepts 27kHz to >100kHz
OUTPUTS
Connectors: XLR male, 6 or 12; BNC chassis mount, 12 or 24
Levels: XLR, 4Vp-p loaded at 110 ohms; BNC, 2Vp-p loaded at 75 ohms
Impedances: XLR, 110 ohms, balanced, transformer isolated and capacitor coupled; BNC, 75 ohms, unbalanced, capacitor coupled
Output Jitter: <3 nanoseconds peak-to-peak at 96kHz sample rate
Output Delay: Three frames (sample intervals) at the sample rate
INDICATORS
Power: Lit RED for ON
POWER Internal supply, 115/230VAC+/-10%, 50/60Hz, 10VA, IEC320 3 pin connector
SIZE 1 RU, 48.3cm W X 4.5cm H X 18cm D
Weight: 4.5kg