1X8 Distribution Amplifier, signal present and clipping LEDs, +24dBm Output, Phono Jack, Term Strip I/O

Avoid RF and hum pick-up problems from noisy, lossy splitters. Prevent hard-to-find shorts from multiple taps on critical lines. Boost low console outputs. Drive long lines. Eliminate rolloff and distortion from mismatched load impedances. These ATI DAs are designed for permanent rack mounting and use reliable barrier block connectors with fan-out strips for easy prewiring and quick change servicing.
The DA1000 and the DA2008 each have a single, high output, active balanced driver per
channel that is resistively split into 4 or 8 outputs each, all driven at precisely the same level.
These economical units feature output clipping LEDs and a headphone/metering jack in a half rack package that you can mount singly or side-by-side in only 1RU of vertical space.

• Output clipping indicators
• Signal present indicator (DA1000 only)
• Front phone jack for headphones, metering or auxiliary ninth output
• Single or dual side-by-side rack mounting kits
• Eight active balanced outputs with +26dBm each; full short circuit isolation
• Heavy common mode bypassing of all output and input lines for superior RF protection
• High slew rate design provides totally transparent operation

OUTPUT LEVEL	+26dBm into 600 ohms
DISTORTION	0.001% typical THD 20Hz to 20kHz
FREQUENCY RESPONSE	+/-.25dB, at 20 to 20,000 Hz, -3dB at 100 kHz
NOISE	-100dBm EIN, 20Hz-20kHz
CROSSTALK	70dB minimum @1kHz
GAIN	26dB; front panel input level controls
INPUTS	30Kohm balanced bridging
HUM REJECTION	80dB hum CMR 60-120Hz
MOUNTING	21075-501 Accessory Rack Shelf mounts two units side by side
TERMINALS	Rear Barrier Block; Fanning Strip supplied
POWER	115 VAC+/-10%, 47-63 Hz; 230 VAC with internal wiring change*
SIZE	8-1/2" (21.6cm) W x1-3/4" (4.4cm) H x 7" (17.8cm) D
WEIGHT	4 pounds (1.8kg)
WARRANTY	Limited, One Year Warranty